EMODnet Seabed Habitats consortium
Title | Copyright or Terms of Use |
---|---|
Broad Habitat - Deep Sea Habitats (EUSeaMap2 - EUNIS) - July 2019 |
Output of the 2019 EUSeaMap broad-scale predictive model, produced by EMODnet Seabed Habitats. The extent of the mapped area includes the Mediterranean Sea, Black Sea, Baltic Sea, and areas of the North Eastern Atlantic extending from the Canary Islands in the south to the Barents Sea in the north. The map was produced using a "top-down" modelling approach using classified habitat descriptors to determine a final output habitat. Habitat descriptors (excepting Substrate) are calculated using underlying physical data and thresholds derived from statistical analyses or expert judgement on known conditions. The model is produced using R and Arc Model Builder (10.1). The model was created using raster input layers with a cell size of 0.00104dd (roughly 100 metres). The model includes the sublittoral zone only; due to the high variability of the littoral zone, a lack of detailed substrate data and the resolution of the model, it is difficult to predict littoral habitats at this scale. This map follows the EUNIS 2007-11 classification system where it is appropriate. It has also been classified according to MSFD Benthic Broad Habitat types. This layer depicts the Deep Sea Habitats derived from the EUSeaMap2. These are habitats occurring beyond the continental shelf break at depths typically greater than around 200m. Knowledge of these habitats is very patchy and limited but is growing all the time, revealing more and more about the rich diversity of life found in the deep waters off Scotland. Please cite EMODnet seabed habitats when using these data or products. Information contained here has been derived from data that is made available under the European Marine Observation Data Network (EMODnet) Seabed Habitats project (www.emodnet-seabedhabitats.eu), funded by the European Commission’s Directorate-General for Maritime Affairs and Fisheries (DG MARE). The Data Owner and EMODnet Seabed Habitats consortium accept no liability for the use of this data or for any further analysis or interpretation of the data. |
Broad Habitat - Subtidal Sediment (EUSeaMap2 - EUNIS) - July 2019 |
Output of the 2019 EUSeaMap broad-scale predictive model, produced by EMODnet Seabed Habitats. The extent of the mapped area includes the Mediterranean Sea, Black Sea, Baltic Sea, and areas of the North Eastern Atlantic extending from the Canary Islands in the south to the Barents Sea in the north. The map was produced using a "top-down" modelling approach using classified habitat descriptors to determine a final output habitat. Habitat descriptors (excepting Substrate) are calculated using underlying physical data and thresholds derived from statistical analyses or expert judgement on known conditions. The model is produced using R and Arc Model Builder (10.1). The model was created using raster input layers with a cell size of 0.00104dd (roughly 100 metres). The model includes the sublittoral zone only; due to the high variability of the littoral zone, a lack of detailed substrate data and the resolution of the model, it is difficult to predict littoral habitats at this scale. This map follows the EUNIS 2007-11 classification system where it is appropriate. It has also been classified according to MSFD Benthic Broad Habitat types. This layer depicts the Subtidal Sediment Habitats derived from the EUSeaMap2. Inshore subtidal sediments include shingle, gravel, sand and mud extending to the depth at which there is no effect from waves, typically around 50-70m. The shelf sediments extend to around 200m depth. Inshore subtidal sediments also include lagoons and maerl, a red seaweed with a hard chalky skeleton that forms small twig-like nodules which accumulate to form loosely interlocking beds, creating the ideal habitat for a diverse community of organisms. Please cite EMODnet seabed habitats when using these data or products. Information contained here has been derived from data that is made available under the European Marine Observation Data Network (EMODnet) Seabed Habitats project (www.emodnet-seabedhabitats.eu), funded by the European Commission’s Directorate-General for Maritime Affairs and Fisheries (DG MARE). The Data Owner and EMODnet Seabed Habitats consortium accept no liability for the use of this data or for any further analysis or interpretation of the data. |
Broad Habitat - Subtidal Rock (EUSeaMap2 - EUNIS) - July 2019 |
Output of the 2019 EUSeaMap broad-scale predictive model, produced by EMODnet Seabed Habitats. The extent of the mapped area includes the Mediterranean Sea, Black Sea, Baltic Sea, and areas of the North Eastern Atlantic extending from the Canary Islands in the south to the Barents Sea in the north. The map was produced using a "top-down" modelling approach using classified habitat descriptors to determine a final output habitat. Habitat descriptors (excepting Substrate) are calculated using underlying physical data and thresholds derived from statistical analyses or expert judgement on known conditions. The model is produced using R and Arc Model Builder (10.1). The model was created using raster input layers with a cell size of 0.00104dd (roughly 100 metres). The model includes the sublittoral zone only; due to the high variability of the littoral zone, a lack of detailed substrate data and the resolution of the model, it is difficult to predict littoral habitats at this scale. This layer depicts the Subtidal Rock Habitats derived from the EUSeaMap2. Subtidal rock habitats comprise bedrock, boulders and cobbles occurring below low water mark. The communities found here are strongly affected by the availability of light; shallow areas are typically dominated by seaweeds and in deeper areas below the photic zone (about 50m) communities comprise exclusively animals. Other factors influence the composition of communities including wave action, tidal stream strength and salinity. Please cite EMODnet seabed habitats when using these data or products. Information contained here has been derived from data that is made available under the European Marine Observation Data Network (EMODnet) Seabed Habitats project (www.emodnet-seabedhabitats.eu), funded by the European Commission’s Directorate-General for Maritime Affairs and Fisheries (DG MARE). The Data Owner and EMODnet Seabed Habitats consortium accept no liability for the use of this data or for any further analysis or interpretation of the data. |
Broad Habitat - Broad-Scale Predictive Habitat Map (EUSeaMap2 - EUNIS) (WMS) |
Output of the 2021 EUSeaMap broad-scale predictive model, produced by EMODnet Seabed Habitats. The extent of the mapped area includes the Mediterranean Sea, Black Sea, Baltic Sea, and areas of the North Eastern Atlantic extending from the Canary Islands in the south to the Barents Sea in the north. The map was produced using a "top-down" modelling approach using classified habitat descriptors to determine a final output habitat. Habitat descriptors differ per region but include: Biological zone Energy class Oxygen regime Salinity regime Seabed substrate Riverine input Habitat descriptors (excepting Substrate) are calculated using underlying physical data and thresholds derived from statistical analyses or expert judgement on known conditions. The model is produced using R and Arc Model Builder (10.1). The model was created using raster input layers with a cell size of 0.00104dd (roughly 100 metres). The model includes the sublittoral zone only; due to the high variability of the littoral zone, a lack of detailed substrate data and the resolution of the model, it is difficult to predict littoral habitats at this scale. EUSeaMap is classified into EUNIS 2019 level 3 (or more detailed levels where appropriate), EUNIS 2019 level 2 , EUNIS 2007-2011, the MSFD benthic broad habitat types, the HELCOM HUB classification in the Baltic, and the recently revised habitat classification in the Mediterranean. In the Black Sea, EUSeaMap is not classified into EUNIS 2007-2011 (due to inapplicability), but is classified according to a classification that was developed by EMODnet Seabed Habitats (Populus et a, 2017, and for a revised version Vasquez et al, 2020, See Online resources). Reports that provide methods used for the classification of the predicted habitats into the new 2019 EUNIS classification, regional classifications, and MSFD BBHT (v.2017) are linked in Online Resources. A report on the methods used in the 2021 version of EUSeaMap (Vasquez et al., 2021) and reports on previous versions (v2016 and V2019) are linked in Online Resources. Credit: Licensed under CC-BY 4.0 from the European Marine Observation and Data Network (EMODnet) Seabed Habitats initiative (www.emodnet-seabedhabitats.eu), funded by the European Commission. |
